Skip to main content

Log a run from screenshots

Interval session on the watch, ten splits to type in? Co-driver Pro reads the lap breakdown straight from your screenshots and pre-fills the segments — you review, adjust, and log.

[[SCREENSHOT OF THE "REFINE WITH CO-DRIVER PRO" PANEL IN LOG RUN]]

How it works​

  1. Open Log run (for an open run, or from a planned session).
  2. In Refine with Co-driver Pro, choose Add screenshots and add up to 5 screenshots of your watch or training app's lap/interval list — Garmin, Apple Fitness, Strava, COROS, Polar… any of them. PNG, JPG, and WebP work.
  3. Tap Read screenshots. Co-driver extracts the laps — distance, time, pace, and heart rate where visible — and shows them as suggested segments.
  4. Review the suggestions, then Apply to run. The segment rows below are replaced with the suggestions — and stay fully editable before you log.
  5. Save the run as usual.

Nothing is stored until you log. The suggestions are pre-fills, not a verdict — you can change or discard every value. Your screenshots are read in memory and never saved anywhere.

Matching against your plan​

Logging against a planned session? Co-driver also aligns each lap to your planned segments and marks the ones it matched ("Matched to your plan"), with a gentle hint where a lap differs noticeably from the plan. It's guidance for your review — never a pass/fail judgement of your run.

Screenshots that work best​

  • The lap or interval list — the table of splits — not the summary page or the map.
  • Sharp, well-lit, tightly cropped. Long lists are fine split across several screenshots.

If Co-driver can't read an image you'll see "Couldn't read those" — try a clearer crop, or just log the segments by hand as usual.

Limits​

Screenshot reads are capped per day (currently 20) so the feature stays fast and free for everyone. Hit the cap and you can keep logging manually — the cap resets daily.

Next steps​